Replacing a western toilet is a bit more involved than replacing a toilet seat cover or other small bathroom fixtures. Here are the steps you can follow to replace a western toilet:
-
Turn off the water supply: Locate the shut-off valve for the water supply to the toilet and turn it off by turning the valve clockwise.
-
Remove the old toilet: Disconnect the water supply line from the bottom of the tank, either by unscrewing it or by using pliers to loosen the nut. Use a wrench to remove the nuts and washers holding the toilet to the floor. Carefully lift the toilet off the floor and place it aside.
-
Prepare the area: Clean the area where the old toilet was located and remove any old wax or sealant from the drain hole.
-
Install the new toilet: Place the new wax seal on the drain hole, making sure it is centered and flat. Carefully place the new toilet onto the wax seal, making sure the bolt holes in the base of the toilet line up with the holes in the flange. Insert the bolts into the flange and through the holes in the base of the toilet. Use new nuts and washers to attach the toilet to the floor. Tighten the nuts until the toilet is secure, but be careful not to over-tighten them and crack the porcelain.
-
Reconnect the water supply line: Connect the water supply line to the bottom of the tank, either by hand-tightening it or by using pliers to tighten the nut. Make sure the hose is securely attached to the tank.
-
Turn on the water supply: Turn on the shut-off valve to restore the water supply to the toilet. Check for leaks around the base of the toilet and the water supply line.
-
Test the flush: Flush the toilet a few times to ensure that it is functioning properly and that there are no leaks.
That's it! Replacing a western toilet can be a bit of a challenge, but by following these steps and being careful during the process, you can successfully replace your old toilet with a new one. If you're not comfortable with plumbing work, it may be best to hire a professional from Locals4u for assistance.